Installation and Owner s Instructions

Size: px

Start display at page:

Download "Installation and Owner s Instructions"

Susanna George
6 years ago
Views:

1 Installation and Owner s Instructions Water Dpenser Th refrigerat equipped with an optional dpenser. Installation Manual and Owner s Manual do include instructions about th option. Please use se instructions f Installation and Operation dpenser. Keep se instructions with refrigerat Installation Manual and Owner s Manual f future use. Englh French NORCOLD, Inc. P.O. Box 4248 Sidney, OH Ncold Cusmer Suppt Dept. Telephone: Fax: Web Site: Part No A (806)

2 Table Contents Owner s Instructions... 2 Water Dpenser... 2 Water dpenser operation... 2 Water dpenser shut f... 3 Task light... 3 Drain grid and drip cup... 3 Water dpenser cleaning and dinfecting... 3 Water Dpenser Stage... 4 Replacement Parts... 4 Wiring Pictial... 4 Wiring Diagram... 5 Troubleshooting... 6 Installation Instructions... 7 Install Water Dpenser Components (nonmetal do models)... 7 Install Water Dpenser Components (metal do models)... 7 Install Decative Do Panels (nonmetal do models)... 7 Connect Water Dpenser... 8 Water Dpenser Owner s Instructions dpenser assembled refrigerats at facty as optional equipment. If refrigerat does have a facty installed dpenser, one can be added refrigerat at a later time. dpenser has a reservoir that built in rear refrigerat fresh food compartment. As dpensed, reservoir aumatically refills with. reservoir allows supply cool same temperature as inside refrigerat fresh food compartment. Most manufacturers have a filter installed in plumbing system remove od, taste, chline, and sediment from. If does already have a filter installed, Ncold recommends that you install one befe operating dpenser. Contact. dpenser operates only on demand and will operate in ambient temperatures as low as 0 F. To allow operation at temperatures between 0 F and 32 F., dpenser has a heater on solenoid valves and on line between solenoid valves and dpenser. At temperatures below 0 F, ste dpenser as written in Water Dpenser Stage section se instructions. CAUTION: line heater does protect supply line from shut f valve solenoid valves on back refrigerat. Do allow temperature inside refrigerat fresh food compartment be less than 32 F. At th temperature, inside reservoir will freeze and damage reservoir. If shut down during cold wear, ste dpenser as written in Water Dpenser Stage section se instructions. dpenser operates on: 12 Volts DC. Potable at a pressure 15 psi 125 psi. CAUTION: Connect dpenser only a potable supply. dpenser system does make untreated potable. dpenser made operate with. Do connect dpenser any beverage source. convenient features dpenser are: one hand operation. a task light which comes on while dpenser on. a drain grid and drip cup which are removable f easy cleaning. a message center, on nonmetal do models) which provides a location f es, reminders, etc. Water dpenser operation: First time operation: first operation dpenser removes air from dpenser system. 1. Remove label from dpenser. NOTE: Do pull on dpenser arm. If you accidently pull dpenser arm f dpenser, make sure coil spring over round stud dpenser and press dpenser arm on dpenser until it snaps in position. 2. Open shut f valve. 3. Hold a glass below dpenser nozzle. Owner s Manual 2

3 4. Push in and hold dpenser arm [189] until flows out in a steady stream and does sputter ( Art01817). NOTE: Th may take a minute f builtin reservoir fill f first time and eliminate air from system. You should dcard and use first several glasses from dpenser. New plumbing connections and/ impurities in supply line from first use after winterizing can cause first glasses be dcoled have an odd flav. 5. Release paddle sp flow Remove glass from below dpenser nozzle. Continued operation: 1. Allow in dpenser cool befe using dpenser. Art01817 cooling time will vary with supply temperature. A complete refill builtin reservoir will take longer 2. Make sure that air inside refrigerat can freely circulate around reservoir which located at rear fresh food compartment. NOTE: Do stack food tightly in front reservoir. If air inside refrigerat can circulate around reservoir, in dpenser will cool crectly. Do set hot food against front reservoir. 3. Hold a glass below dpenser nozzle. 4. Push in and hold dpenser arm start flow. 5. Release paddle sp flow Remove glass from below dpenser nozzle. Water dpenser shut f: If dpenser does shut f when you release paddle: Push refrigerat ON/OFF butn turn refrigerat f. Art01818 Troubleshooting section se instructions find cause problem. Task light: task light comes on whenever dpenser on. Drain grid and drip cup: drain grid and drip cup are located below dpenser arm. To remove drain grid [191], push down on center rear edge drain grid rae up front edge so you can grasp it ( Art01818). 192 To remove drip cup [192], grasp handle area inside drip cup and lift it out well ( Art01819). Art01819 Owner s Manual 3

4 Water dpenser cleaning and dinfecting: To clean drain grid and drip cup: Remove drain grid and drip cup from well. Wash dpenser, drain grid, and drip cup with a mild cleaner a solution liquid dh detergent and warm. Rinse with clean. Dry with clean cloth. NOTE: Do use abrasive cleaners, chemicals, scouring pads because y can damage finh parts. Put drain grid and drip cup back in iginal positions. Follow instructions RV manufacturer dinfect drinking supply. Occasionally food liquid spills may fall in reservoir area. F ease removal and cleaning, cover attached inside refrigerat with velcro. To clean cover [194] and reservoir [195] ( Art01821): Remove wire shelves and crper bins from refrigerat. Remove reservoir cover. 194 Put finger through cover at a cner and gently pull cover fward loosen velcro tab at cner. Slide finger around back cover next velcro tab. 41 Gently pull cover fward loosen velcro tab. Repeat until cover removed. Wash reservoir, cover, and area around reservoir with a mild cleaner a solution liquid dh detergent and warm. 195 If you need clean behind reservoir, remove two screws [41] that attach reservoir refrigerat cabinet. Gently clean behind reservoir. Put two screws back in iginal position. Art01821 Owner s Manual 4

5 Water Dpenser Stage To prepare dpenser f seasonal stage ( Art01822): CAUTION: Do operate dpenser when ambient air temperature 0 F. lower. Damage solenoid valves and supply line can occur. 1. Close supply valve refrigerat. 2. Remove supply line [43] from solenoid valve [44]. 3. Remove dpenser line from solenoid valve. Do remove foil heaters from around solenoid valve and dpenser line CAUTION: Drain dpenser. Failure drain dpenser can cause damage dpenser components and result in leaks. Art Drain all from supply line and dpenser line. NOTE: Make sure use a large enough container catch that drains from dpenser line. dpenser contains almost a quart. 5. Put ends lines and solenoid valve each in a clean plastic bag. 6. Use tape close each plastic bag around lines and solenoid valve. To use dpenser after seasonal stage: 1. Remove tape and plastic bags from end lines and solenoid valve. 2. Connect dpenser line solenoid valve. 3. Connect supply line solenoid valve. 4. Open supply valve refrigerat. 5. Push and hold dpenser arm until comes out in a steady stream and does sputter. NOTE: You should dcard and use first seven glasses from dpenser. Replacement Parts You may purchase replacement parts through local RV authized Ncold Owner s Manual 5

6 Owner s Manual 6 Troubleshooting roblem P n Solutio warm. o filled. was reservoir dpenser since hours 4 least been at has it with food. loading befe hours 8 f operated has refrigerat reservoir. tightly in front stacked food reservoir. front against food hot enough temperature. cold a set control temperature refrigerat crectly. cooling refrigerat Ncold authized dpense. does fully open. / on and source pump open. dpenser supply valve clogged. supply system filter valves. solenoid connected supply line VDC. 12 crrectly connected valve solenoid freely. arm moves dpenser Ncold authized f. shut does controls. refrigerat at "OFF" refrigerat Turn dpenser. source remove pump Turn f controls. refrigerat at "ON" refrigerat Turn freely. moves paddle dpenser out. freely in and moves paddle dpenser butn behind round small deenergized. when it closes valve Ncold authized weak flow sputtering. clogged. supply system filter kinked. are refrigerat behind lines low. pressure fully open. are dpenser leading valves any lines. from purged air all filter, replacing winterizing after clean with a so If deposits. mineral up build have does nozzle dpenser tip cloth. st swab Ncold authized an od has taste. bad replaced. be may need filter installed. be may need filter a sanitized. be system may need. glasses several out by running purged reservoir dpenser Ncold authized on. come does light task VDC. 12 crrectly connected valve solenoid Ncold authized f. go does light task freely. arm moves dpenser Ncold authized Art01713

7 Installation Instructions Install Water Dpenser Components (nonmetal do models) 1. Install back splash assembly ( Art01820): Put hook on botm back splash assembly [193] down in slot [157] dpenser panel. Align two (2) rectangular mounting studs on rear back splash assembly with two (2) mounting lugs [196] on dpenser panel. Using equal pressure, push both mounting studs in mounting lugs at same time. mounting studs should engage and lock in mounting lugs with a click sound. Install Water Dpenser Components (metal do models) Install back splash assembly ( Art01820): 157 Put hook on botm back splash assembly [193] down in slot [157] dpenser panel. Align two (2) rectangular mounting studs on rear back splash assembly with two (2) mounting lugs [196] on dpenser panel. Using equal pressure, push both mounting studs in mounting lugs at same time. mounting studs should engage and lock in mounting lugs with a click sound. Art01820 Owner s Manual 7

8 Install Decative Do Panels (nonmetal do models) NOTE: dos are made accept decative panels. decative panels must be 3/16 inch less in thickness. Install decative do panels in refrigerat dos befe installing refrigerat in. 1. Make two upper do panels that are 17 1/4 inches wide x 23 1/8 inches high: Raed panels must be centered on each do and no larger than 16 1/2 inches wide x 22 3/8 inches high Make a lower RH do panel that 17 1/4 inches wide x 42 5/16 inches high: Raed panels must be centered on lower RH do and no larger than 16 1/2 inches wide x 41 9/16 inches high. 3. Make a lower LH do panel that 17 1/4 inches wide x 34 5/8 inches high: 37 Art01804 Raed panels must be centered on lower LH do and no larger than 16 1/2 inches wide x 33 7/8 inches high. 4. Install decative do panels: Pull panel retainer [37] f each do [39] ( Art01804). Push a decative do panel [38] in slots each do. 37 Make sure that each panel retainer crectly positioned and push curved snap [125] panel retainer [37] inside curved snap [126] do ( Art01805). Make sure that decative do panel [36] lower LH refrigerat do behind dpenser panel Art01805 Owner s Manual 8

9 Connect Water Dpenser dpenser assembled refrigerat at facty as optional equipment. If refrigerat does have a facty installed dpenser, one can be added refrigerat at a later time. refrigerat installer must connect a cold supply line solenoid valve at rear refrigerat. following are necessary connect dpenser. 1/4 in. OD copper tubing f supply line. 1/4 in. OD plastic tubing f supply line. 1/4 in. shut f valve in supply line. Th should be easily accessible through lower intake vent. Connect supply line: Install a 1/4 in. OD supply line [43] from shut f valve solenoid valve [44] at rear refrigerat ( Art01822): NOTE: A brass compression nut [45], a brass sleeve, a plastic sleeve [46], and a brass insert [47] are supplied and attached rear refrigerat ( Art01702). Put compression nut and n sleeve on supply line [43]. F copper tubing, use brass sleeve. F plastic tubing, use plastic sleeve [46]. OR F plastic tubing with.040 in. wall thickness, also use brass insert [47]. Flush supply line until clear. Put supply line in compression fitting solenoid valves. Art Tighten compression nut by hand (hard finger tight). Using two wrenches, tighten compression nut 1 ½ 2 turns Open shut f valve. Examine connections f leaks. Art01702 Owner s Manual 9

10 Owner s Manual 10

Norcold Repair Guide for Ice Maker

Norcold Repair Guide for Ice Maker Section 10 Table of Contents Page: 10-2 General Description 10-2 Refrigerator Specifications 10-2 Refrigerator Operating Limits 10-2 Refrigerator Current Draws 10-2 Ice