IMPORTANT SERVICE BULLITEN

Transcription

1 IMPORTANT SERVICE BULLITEN October 23, 2014 Dealership Service Department Service Procedures addressing the following models: Backpack Pop-Up Campers manufactured by Palomino R.V. Division of Forest River, Inc. Kit Installation Instructions for Remote Roof Lift and Non-Remote Roof Lift System: In our continuing effort to build a better product we have discovered that some infrared interference may engage the electric lift. This kill switch On/Off that is being installed per this bulletin will prevent frequency interference when used properly by the consumer. Please see Figure 1 for the current As Wired review. Reference; Figure 1 1. Orange Wire is Hot wire from source into the lift system. 2. Mark the terminal where Orange wire is hooked for reference. 3. Unhook the wire from the switch and leave free at this time. Owner Notification; Campaign ID Number: FR Page 1

2 Continued Adding the 12v On/Off Switch will interrupt the power flow when used properly by the customer. Locate a position close to the Reico-Titan Switch and boar a hole to fit the 12v switch into snugly. 1. Drill Hole in panel or style to place 12v switch 2. Using included Jumper Wire connect Reico-Titan Switch to On/Off switch ensuring the connections are tight with. This wire should be connected to the Off corresponding blade on the switch. 3. Reconnect the Power Feed from the unit source to the On position of the new switch. Reference Figure 2 1. Test to ensure that the system works as designed by turning the switch to the On position. 2. Run the roof up and down. 3. Turn the switch to the Off position and attempt to cycle the roof. If there is no movement in the roof, the job shall be completed. Owner Notification; Campaign ID Number: FR Page 2

3 For models with the Wireless Roof Lift Remote Option installed by the factory: 1. Cut the Red Wire from the Orange Wire (Orange is Hot from source). 2. Using included bell cap and Jumper Wire connect the Red wire to the supplied Orange Jumper Wire and connect the jumper wire to the Off position on the switch. 3. Connect unit power source wire to the On position to the switch. Reference Figure 3 Here at the plant, we are installing the switched in the units, and have installed many switches in units that had been in our holding yard. Please check to ensure your SS Backpack Truck Campers have this system in place. Owner Notification; Campaign ID Number: FR Page 3

4 Please accept our apologies for this Service Bulletin. We strive for success and we hope that you will ensure that each and every Backpack truck camper you have on the lot or sold will be handled with care. Respectfully, Keith Fisher Engineering Manager, Forest River, Inc. References: Forest River Safety Campaign Number: FR Procedure Reference M1675 Kit Number M1675 Owner Notification; Campaign ID Number: FR Page 4

5 M1675 Kit Contents: 1 Black, 12v On/Off Switch AWG, 600V Moisture Resistant Orange Wire with Pre-fitted Female Blade Ends A. For Non-Remote Optioned Systems Only AWG, 600V Moisture Resistant Orange Wire with Pre-fitted Female Blade End A. For Remote Optioned Systems only. 2 Bell Caps to connect wires together A. For Remote Optioned Systems only Internal use only: VIN Of Unit:: DOM: Kit Checked by: Date: Ship Date: Ensure a Copy of the Owners Notification or ON & Installation Instructions documents are included with each shipment. Affix shipping label copy to this paper. A copy of this paper shall be scanned into the units file once all data is filled out and shipping label attached Owner Notification; Campaign ID Number: FR Page 5