START UP FORM PACKET

Transcription

1 START UP FORM PACKET Condensing Unit DIVISIONS OF RAE CORPORATION 4492 Hunt St. - Pryor, OK (918) Fax (918)

2

3 RAE Corporation Condensing Unit Start-Up Form Century Refrigeration Technical Systems Refrigeration Systems Unit Model #: Unit Serial #: Voltage/PH/Hz: Refrigerant: First Day of Start-Up: Last Day of Start-Up: Job Name: Job Street Address: Job City: Job State and ZIP: Equipment Installation Service Company Information: Company Name: Company Address: Company City: Company State and ZIP: Maintenance & Labor Warranty Service Company Information: Company Name: Company Address: Company City: Company State and ZIP: PART A - Pre Start-Up System Check: Has the unit been checked for shipping damage? Yes No If there is any shipping damage, please list all damage in detail: Crankcase heaters are verified operational and have been on continuously for at least 12 hours? Yes No Has field water piping been verified correct? Yes No Has the air handler been verified operational? Yes No Has an air balance been completed? Yes No Has the evaporator been verified as functional with even refrigerant distribution? Yes No Has all field wiring been verified as completed and checked as functional per electrical diagrams? Yes No

4 Are pressure lines free from compressor, with pressure line coils spaced at least 1 inch apart? Yes No Has all piping been thoroughly leak checked? Yes No Has all field connected main power and control wiring been completed and checked? Yes No Have filter driers been installed if equipped? Yes No Has a grounded conductor been installed from the main panel to earth ground? Yes No Main Voltage Check: Voltage L1 to L2: Voltage L2 to L3: Voltage L3 to L1: Voltage L1 to G: Voltage L2 to G: Voltage L3 to G: Main fuse or breaker size: Control Voltage Check: PART B - Start-Up: amps Voltage H to N: Voltage H to G: Voltage N to G: Ambient temperature: F Setpoint: F Amount of refrigerant in system: lbs. of R- in each circuit. Compressor and Circuit Operation: Compressor Number Amps/leg Suction Discharge Superheat 1 / / PSI PSI F 2 / / PSI PSI F 3 / / PSI PSI F 4 / / PSI PSI F 5 / / PSI PSI F 6 / / PSI PSI F 7 / / PSI PSI F 8 / / PSI PSI F Blower Fan Amps/leg Volts/leg Is blower/fan rotation correct? 1 / / / / Yes No 2 / / / / Yes No 3 / / / / Yes No 4 / / / / Yes No 5 / / / / Yes No 6 / / / / Yes No 7 / / / / Yes No 8 / / / / Yes No 9 / / / / Yes No 10 / / / / Yes No

5 If hot gas bypass is used, what is it set at? High pressure control setting (cut in/cut out, circuits 1-8): Cut in: Cut out: Low pressure control setting (cut in/cut out, circuits 1-8): Cut in: Cut out: What percentage of load was available at start-up? If a VFD is used, what are the basic settings on the VFD, and/or what was changed on the VFD during start-up and why? N/A At what PSI does the condenser fan/blower start? Safety Check: Have compressor overloads been verified correct? Yes No N/A Settings: #1 #2 #3 #4 Have condenser overloads been verified correct? Yes No N/A Settings: #1 #2 #3 #4 Controller Check: Are controllers labeled and correspond to the diagram? Yes No Was a program downloaded in the field? Yes No If program was field downloaded, what version was used? Have controllers been scrolled through line by line ensuring that all transducers, sensors, pumpdown switches, failures, GPM, etc. read correctly? Yes No List any fields not reading correctly: Have all changes to any parameter been documented and sent to the lab, programming, and service? Yes No List any parameters or settings that were changed: Have all adjustable refrigeration valves been adjusted appropriately? Yes No Which valves were adjusted?

6 Other: Does any work need to be completed on the unit after start-up? Yes No Please list any additional work in detail: Start-Up Notes: Start-up performed by (Print): Start-up performed by (Signature): Date: To validate equipment parts warranty, return completed form within (10) day of start-up to: RAE Corporation Attn: Service Department P.O. Box 1206 Pryor, OK (918)

7

8 P.O. Box Pryor, OK (918) Fax (918) Bulletin# CONDENSING-START UP-0518