ELVI Electronic Low-Voltage Interface

Transcription

1 Electronic Low-Voltage Interface elvi Description Provides capability for GAFIK Eye 000 Series s and LP Dimming s to dim electronic transformer-supplied low-voltage lighting. Provides power and dimming for one zone. Models available for 0V, 0-0V (non-ce), 0V (CE) or 00V input power. Works with: GAFIK Eye 000 Series s LP Dimming s HomeWorks emote Power s -referenced fluorescent wallbox dimmers by Lutron. Models and Capacities Input Power 0V 0-0V (non-ce) 0V (CE) 00V Capacity 000W/VA 00W/VA 00W/VA 000W/VA Model Number -000 NGX--AU-WH NGX--CE-WH NGX--JA-WH Two Interfaces may be used on a zone to double the capacity.

2 Specifications elvi Power Input power: 0V, 0-0V (non-ce), 0V (CE), or 00V. All voltages 50/60 Hz, phase-to-neutral. Load (output) power: Phase independent of Control Unit. Sources/Load Types Operates electronic low-voltage lighting with a smooth continuous Square Law dimming curve or on a full conduction non-dim basis. Does not affect sound rating of electronic transformers. Does not cause lights to flicker or interact anywhere in dimming range. Dims to 0% (blackout). Works only with electronic (solid-state) low-voltage transformers that are manufacturer-approved for reverse-phase control dimming. Incandescent and electronic low-voltage sources may be controlled on the same zone. Up to 0% of the capacity may be used for incandescent lighting. Key Design Features Patented TISSTM circuitry compensates in real time for incoming line voltage variations: No visible flicker with +/-% change in MS voltage/cycle and +/- % Hz change in frequency/second. Terminals Accept up to two # AWG (.5mm ). Environment -0 F (0-0 C). elative humidity less than 90% non-condensing. Mounting Surface or recess mount indoors only.

3 Dimensions And Mounting elvi ecess or surface mount in -gang U.S. wallbox.5" (89mm) deep. Indoors only. Interface generates heat; mount only where ambient temperature is -0 F (0-0 C). Mount with arrows facing up to ensure adequate cooling. Allow.5" (mm) above and below unit and between faceplates when mounting several in a vertical layout. For better heat dissipation, surface mount without faceplate. Mount so line (mains) voltage wiring is at least 6 feet (.8m) from sound or electronic equipment and wiring. Mount Interface within 7 of true vertical. ecess Mount with Faceplate " (00mm) Surface Mount without Faceplate Side View 9/6" (6mm) -Gang U.S. Wallbox 7/8" (8mm) /6" (7mm)

4 Wiring elvi Pull # AWG (.5mm ) Copper (Cu) wires (75 C minimum) for input power and load circuit. Strip /" (mm) insulation from wires before connecting. un separate neutral for load circuit - no common neutrals. (N) terminal is for, not the load neutral. Single Power Feed The Interface may be on the same circuit as the only if the total load does not exceed the rating of the breaker. ear View of NEUTAL CU WIE USA: Class GX-0 Feed from Load Multiple Power Feeds The load breaker/mcb may be on a different phase than the control breaker/mcb. ear View of NEUTAL CU WIE USA: Class GX-0 Feed from Load Feed from

5 Wiring elvi Two Interfaces on a Zone ear View of ear View of NEUTAL CU WIE USA: Class GX-0 Feed from Load Feed from With Other Lutron Lighting Controls To wire an Interface to a fluorescent dimmer: un a wire from the control equipment to on the. un a dimmed hot wire from the control equipment to on the.