OWNER S MANUAL. Replacement Canopy for Grandview Gazebo. Product code: D71 M12209 UPC code: Vendor Item: C-I-138-2NGZ

Transcription

1 OWNER S MANUAL Replacement Canopy for Grandview Gazebo Product code: D71 M12209 UPC code: Vendor Item: C-I-138-2NGZ Date of purchase: / / 1

2 PARTS Read through all the instructions before beginning assembly. Unpack and identify all the parts. Place them on a flat, non-abrasive surface. Assembly by two people is recommended. A1 (1) Original Short Canopy Frame (not included in this package) A2 (1) Original Long Canopy Frame (not included in this package) B (1) New Wind Vent Canopy C (1) New Large Canopy ACCESSORIES Use the following parts from your original gazebo Use the following parts from the hardware Da (6) Bolt Dd (1) Assembly Instructions Sheet Db (12) Metal Washer De (1) Allen Wrench Dc (6) Nut Df (1) Open Hex Wrench 2

3 Special Warning Assemble your gazebo on a soft, non-abrasive surface to avoid damage. The gazebo is heavy. Use care when handling. Assembly by six adults is recommended. The gazebo is not intended to be a permanent structure. Take it down during high winds or it may be damaged. KEEP ALL FLAME AND HEAT SOURCES AWAY FROM CANOPY FABRIC The canopy is made with flame-resistant fabric which meets CPAI-84 specifications. It is not fireproof. The canopy fabric will burn if left in continuous contact with flame source. The application of any foreign substance to the canopy fabric may render the flame-resistant properties ineffective. ASSEMBLY INSTRUCTIONS Process of removing gazebo canopy 1 Release the hooks and pull out the long canopy frame bars (A2) from the canopy corner pockets. See Fig. 1 and Fig. 2. Fig. 2 Fig. 1 2 Remove all of the bolts, metal washers and nuts which are attached on the long canopy frame bars. See Fig. 3. Fig. 3 Fig. 5 3 Pull out the short canopy frame bars (A1) from the wind vent canopy corner pockets and open the Velcro tabs which connected the canopies. See Fig. 4. Press the pushpin in the cylinder that connects the top and bottom canopy supports and lift evenly to remove canopy support bars. See Fig. 5. Remove the short canopy frame from the large canopy frame. See Fig. 6. Fig. 6 Fig. 4 3

4 4 Remove the old wind vent canopy from short canopy frame bars (A1). See Fig. 7. Remove the old large canopy from the long canopy frame bars (A2). See Fig. 8. Fig. 7 Fig. 8 Process of replacing new gazebo canopy Fig. 9 5 Place the new large canopy (C) over the long canopy frame (A2) and spread to the location. See Fig. 9. Place the new wind vent canopy (B) over the short canopy frame (A1). See Fig. 10. Fig Attach the assembled short canopy frame (B&A1) to the assembled long canopy frame (C&A2). Push down the button and insert long canopy frame center (A2) into the short canopy frame center piece (A1), make sure the button fits securely into the hole. See Fig. 11. At the same time, insert long canopy frame bars (A2) into short frame bars (A1). See Fig. 12. From inside of the canopy, fasten Velcro tabs to connect the wind vent canopy (B) with the large canopy (C). Insert each end of the short canopy frame bars (A1) into the pockets of the wind vent canopy (B). See Fig. 13. Fig. 12 Fig. 11 Fig. 13 4

5 7 Place the completed canopy onto the top of assembled leg posts. Line up the holes, insert a bolt (Da) through a metal washer (Db), through a long canopy frame bar (A2), through the bracket, through another metal washer (Db) and secure with a nut (Dc). Don t tighten completely. Repeat procedure for the remaining five canopy frame bars (A2). Tighten all bolts and nuts. See Fig. 14. Fig Pull down the edges of the canopy fabric and insert each tip of the canopy frame bar (A2) into the pocket of the canopy fabric. See Fig. 15. Fasten the canopy and net to the leg posts with the hooks. See Fig. 16. Fig. 15 Fig. 16 Your gazebo with new canopy is now ready for use. CARE INSTRUCTIONS Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents. Cover furniture with outdoor furniture covers when not in use. Please refer to part numbers when reordering For questions or comments about product: Call toll-free: Made in / Hech en CHINA Distributed by Sears, Roebuck and Co., Hoffman Estates, IL sears.com See our extensive assortment of outdoor living products on-line at and 5