S-4404-TRM Carrington Tub/Hand Shower Trim Operation & Maintenance Manual

Transcription

1 -4404-TR arrington Tub/and hower Trim peration & aintenance anual odel Numbers pecifications TR Tub/and hower Trim Tub/hand shower trim with lever handle and secondary integral diverter handle includes wall connection, cradle for hand shower mounting, non-diverter tub spout, in-line vacuum breaker, flexible metal hose and mode hand shower with.5 gpm (9.5 /min) flow restrictor. omponents made from metal and nonmetallic materials plated in standard polished chrome finish. odifications gpm (5.7 /min) flow restrictor gpm (7.6 /min) flow restrictor Warranty imited ifetime - to the original end purchaser in consumer installations. 5 Years - for commercial installations RP - -TN 0" slide bar in place of wall cradle on hand shower units ross handle in place of white insert handle etal finish insert handle atin nickel finish Refer to for complete warranty information. Note: ppend appropriate -suffix to model number. ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4

2 imensions easurements /8", 5 mm ale /" P thread must be recessed /4" from finished wall Ø 7 /", 9 mm /8", 79 mm Ø 5/8", 67 mm ", 8 mm ", 05 mm /8", 79 mm /4", 70 mm (Rough in) " ± /", 5 mm ± mm /" NPT /", mm 6 /", 65 mm loor Notes: ) ll dimensions measured from nominal rough-in (see as reference). ) imensions are subject to change without notice. ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4

3 Parts reakdown Replacement Parts tem escription Part Number Vacuum reaker 60" ose -04 Wall lbow -05 et crew andle lange -ring -8-P N ock Nut T-0-P Washer 40-P ounting crews scutcheon -4- ome over - R scutcheon Plate 7.5-T N radle ounting crews radle radle ounting Plate -06 P Q P iverter andle -/ Q Tub pout 06 R and hower 44W Notes: ) ppend -TN to part number for satin nickel finish. ) ppend -.5 or -.0 to showerhead or hand shower for low flow. djustable wrench Required for nstallation Phillips head screwdriver llen wrench (/8") Plumber tape ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4

4 nstallation Note: or valve body installation, please see valve body installation guide. ) nstall dome cover () and washer () to valve and secure with lock nut (). 5) nstall tub spout (Q) to pipe fitting. Turn clockwise to secure. ) nstall secondary integral diverter handle (P) into shower escutcheon (). Q P 6) nstall wall elbow () to pipe fitting. Turn clockwise to tighten. ) nstall shower escutcheon plate () and shower escutcheon () to shower valve. ecure with two screws (). 4) nstall o-ring (), flange (), and handle () to valve and secure with screw (). Note: andle should be facing the 6 o'clock position. 4 ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4

5 nstallation 7) Place mounting plate () in position, mark and drill /8" pilot holes into stud. 8) Remove cover of hand shower cradle (N). nstall cradle and mounting plate (). ecure with three screws (). Replace cover on hand shower cradle. N 9) ttach large end of hand shower hose () to hand shower (R). ttach small end of hand shower hose () and gasket to in-line vacuum breaker (). onnect in-line vacuum breaker to wall elbow (). Turn clockwise to tighten. ption: Place mounting plate () in position, mark and drill /6" holes into wall. nstall anchors. R ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4

6 peration Temperature ontrol iverter ontrol ) Turn shower handle counterclockwise approximately /4 turn to put valve in cold position. ) Turn diverter left for tub spout operation. ) Turn shower handle counterclockwise approximately / turn to put valve in warm position. ) Turn diverter right for hand shower operation. ) Turn shower handle counterclockwise approximately /4 turn to put valve in hot position. are and leaning ) lean finished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse with water. Troubleshooting hart Problem ause olution inish is spotting. lements in water supply may cause water staining on finish. lean finished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse with water. 6 ymmons ndustries, nc. rooks rive raintree, 084 (800) ax: (800) ymmons ndustries, nc. gethelp@symmons.com ZV-07 RV 0 09/8/4