Certificate of Compliance

Transcription

1 Certificate of Compliance Certificate: Master Contract: Project: Date Issued: April 08, 2015 Issued to: Bel Fuse Inc. 206 Van Vorst St Jersey City, New Jersey USA Attention: Editha S. Vergara The products listed below are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and US or with adjacent indicator 'US' for US only or without either indicator for Canada only. Issued by: Lai Mei Lam Lai Mei Lam PRODUCTS CLASS - C POWER SUPPLIES-Component Type(CSA nd Ed) CLASS - C POWER SUPPLIES-Component Type(UL nd Ed)Certified to U.S.Stds Component type power supplies intended for use with Information Technology and Business Equipment, where the suitability of the combination is to be determined by CSA Group. AC/DC Switching Power Supply, Models PET NA, PET NAA, PET NAC, PET NACS354 (Cisco P/N: ), PET NA, maybe followed by alpha numeric characters indicating non-safety critical options DQD 507 Rev Page 1

2 Certificate: Project: Master Contract: Date Issued: April 08, 2015 Electrical Rating: Input: / Vac, 12/10 A, 50/60 Hz. Output: see below table. Model PET NA PET NA PET NAA PET NAC, PET NACS354 (Cisco P/N: Input Voltage Output, DC Vac 55 C ambient 70 C ambient V1:12 V, 83.3 A V1:12 Vdc 50 A V1:12 V 133 A V1:12 Vdc 80 A / Vsb: V, 4A Vsb: V, 2.4 A V1:12 V, 83.3 A V1:12 Vdc 50 A V1:12 V 167 A V1:12 Vdc 100 A / Vsb: V, 5 A Vsb: V, 3.0 A APPLICABLE REQUIREMENTS CAN/CSA-C22.2 No , Amendment 1: 2011 (MOD)+Am2:2014 Information Technology Equipment - Safety - Part 1: General Requirements ANSI/UL Information Technology Equipment - Safety - Part 1: General Requirements CONDITIONS OF ACCEPTABILITY 1. This component has been judged on the basis of the required spacings in the Standard for Safety of Information Technology Equipment, CSA/UL , Second Edition, Amendment 2, Sub-clause 2.10, which would cover the component itself if submitted for Listing. 2. The equipment has been evaluated for use in Pollution Degree 2 environment. 3. The Clearance values of the Power Supply Unit (PSU) have been evaluated for an altitude of 10,000ft (3048m), under IEC : 1992 Table A.2 (altitude correction factor is 1.15). 4. Touch Current Test was conducted at 264Vac, 60Hz and measured current for single unit was 1.8mA. 5. The ground path from the appliance inlet to the PSU case meets protective bonding and has been evaluated at 40A. 6. Evaluated as Class I (earthed equipment). Reliable connection to Protective Earth shall be provided in the end use installation. 7. Evaluated for connection to AC power with a branch circuit protector rated max 20 A. DQD 507 Rev Page 2

3 Certificate: Project: Master Contract: Date Issued: April 08, The secondary outputs of the PSU are SELV. 9. The VSB:12.15V output is non-hazardous energy level. 10. The main output ( V1:12 V) is at hazardous energy level, but when removed from the end use product, with no connections to the secondary connectors, the outputs are not an energy hazard even under single fault conditions. 11. The PSU has been evaluated for a TN (Including TN-S and TN-C) and TT systems power source. 12. All Isolating transformers isolation barrier insulation temperatures have been measured within the winding on the insulator. The internal temperature did not exceed the insulation Class limits for NORMAL operation and ABNORMAL operation. 13. The temperature of the Isolating Transformers (T71, T201) employ an OBJY3 electrical insulation system designated Class F. 14. The connector current interruption test (Hot Plugging test) was conducted on the secondary output mating connector (external to the unit, manufactured by FCI Type Power Blade P/N: LF ) of the PSU for 200 cycles. 15. Suitability of the enclosure provided with the equipment as a FIRE, MECHANICAL and ELECTRICAL enclosure is to be determined in the end system except front panel (including top and bottom sides) which complies with the FIRE, MECHANICAL and ELECTRICAL enclosure requirements. 16. The PSU is not intended for use in vehicles, on board ships or aircraft. DQD 507 Rev Page 3

4 Supplement to Certificate of Compliance Certificate: Master Contract: The products listed, including the latest revision described below, are eligible to be marked in accordance with the referenced Certificate. Project Date Description Product Certification History Apr AC/DC Switching Power Supply, Models PET2000 Series and PET1600 Series. (C/US) DQD 507 Rev Page 1

5 CERTIFICATE No. P Order No Page 1/3 Product Applicant Manufacturer AC-DC switching power supply Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ USA Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ USA Factory See page 3 Ratings Trade mark All models except PET NA Input: V~/ V~, 12/10A, 50/60 Hz Output: V1: 12 Vdc, 83.3 A max.( v), 167 A max.( v) VSB: 12.15V, 5A max PET NA Input: V~/ V~, 12/10A 50/60Hz Output: V1: 12 Vdc, 83.3 A max. ( V), 133 A max.( v) VSB: V, 5 A max. Model / Type Ref. Principal characteristics PET NA, PET NAA, PET NAC, PET NA, PET NACS354 (Cisco P/N: ) The model name may be followed by alpha numeric characters indicating nonsafety critical options See next page(s) A sample of the product was tested and found to be in conformity with OFF EN :2006;A11;A1;A12;A2 Validity Additional information This certificate documents conformity with the standards shown, and also applies as license for use of Nemkos name and certification mark. The certificate and license is valid as long as the applicable conditions are complied with, and provided that any changes to the product are notified to Nemko for acceptance prior to implementation. New standards or amendments to the standards may imply that the product design must be updated and/or that re-testing and re-certification is necessary. See next page(s) The abovementioned certified equipment complies with current regulatory requirements regarding electrical safety in Norway and other EU/EEA member states, as far as this can be checked. Compliance with requirements regarding building-in, protection against electric shock and Date of issue Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL FAX info@nemko.com ENTERPRISE NUMBER NO nemko.com

6 CERTIFICATE No. P Order No Page 2/3 Additional model(s) Electromagnetic Compatibility (EMC) must be checked when the equipment is built-in a completed product or forms a part of a complete system. See next page(s) Date of issue Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL FAX info@nemko.com ENTERPRISE NUMBER NO nemko.com

7 CERTIFICATE No. P Order No Page 3/3 Factories: BPS Asia Pacific Electronics (Shenzhen) Co., Ltd. Building# 6, Nanming Road, Gongming Town Huahong Xintong Industrial Park Guangming District, Shenzhen China Bel Power Solutions, s.r.o. Areal ZTS 924 Dubnica nad Vahom Slovakia Date of issue Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL FAX ENTERPRISE NUMBER NO nemko.com

8 Ref. Certif. No. NO86275 IEC SYSTEM FOR MUTUAL RECOGNITION OF TEST CERTIFICATES FOR ELECTRICAL EQUIPMENT (IECEE) CB SCHEME SYSTEME CEI DACCEPTATION MUTUELLE DE CERTIFICATS DESSAIS DES EQUIPEMENTS ELECTRIQUES (IECEE) METHODE OC CB TEST CERTIFICATE CERTIFICAT D'ESSAI OC Product Produit Name and address of the applicant Nom et adresse du demandeur Name and address of the manufacturer Nom et adresse du fabricant Name and address of the factory Nom et adresse de l'usine Note: When more than one factory, please report on page 2 Note: Lorsque il y plus d'une usine, veuillez utiliser la deuxième page Ratings and principal characteristics Valeurs nominales et caractéristiques principales Trademark (if any) Marque de fabrique (si elle existe) AC-DC switching power supply Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ USA Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ USA Additional information on page 2 All models except PET NA Input: V~/ V~, 12/10A, 50/60 Hz Output: V1: 12 Vdc, 83.3 A max.( v), 167 A max.( v) VSB: 12.15V, 5A max PET NA Input: V~/ V~, 12/10A 50/60Hz Output: V1: 12 Vdc, 83.3 A max. ( V), 133 A max.( v) VSB: V, 5 A max. Type of Manufacturer s Testing Laboratories used Type de programme du laboratoire d essais constructeur Model / Type Ref. Ref. De type WMT PET NA, PET NAA, PET NAC, PET NA, PET NACS354 (Cisco P/N: ) Additional information (if necessary may also be reported on page 2) Les informations complémentaires (si nécessaire, peuvent être indiqués sur la deuxième page A sample of the product was tested and found to be in conformity with Un échantillon de ce produit a été essayé et a été considéré conforme à la As shown in the Test Report Ref. No. which forms part of this Certificate Comme indiqué dans le Rapport dessais numéro de référence qui constitue partie de ce Certificat The model name may be followed by alpha numeric characters indicating non-safety critical options Additional information on page 2 IEC (ed.2);am1;am This CB Test Certificate is issued by the National Certification Body Ce Certificat dessai OC est établi par l'organisme National de Certification Gaustadalléen 30 NO-0373 Oslo, Norway Date: Signature: Juan Z. Kleppenes Certification Department Issued /2

9 Ref. Certif. No. NO86275 BPS Asia Pacific Electronics (Shenzhen) Co., Ltd. Building# 6, Nanming Road, Gongming Town Huahong Xintong Industrial Park Guangming District, Shenzhen China Bel Power Solutions, s.r.o. Areal ZTS 924 Dubnica nad Vahom Slovakia Gaustadalléen 30 NO-0373 Oslo, Norway Date: Signature: Juan Z. Kleppenes Certification Department Issued /2

10

11

12

13

14

15