The following modes can be set when the units are installed, and/or can be changed later through use of a push button on the desktop controller:

Transcription

1 OptiStile 720 OptiStile 720 Optical Barrier-type flow control turnstile for Internal Installation with swinging glass doors Technical Specification Orientation: Bi-Directional Unit Dimensions: Casework Length Casework Height Casework Width 6.50 Walkway Width Standard 28.0 Walkway Width (ADA) 36.0 Drive: Motorized Materials: Pedestal: #4 Grained Stainless Steel and tempered glass center section with fully integrated steel frame. Pedestal Lid: #4 Grained Stainless Steel with Corian type solid surfacing or Granite end caps. Construction: Function: Barriers: 0.39 thick tempered glass secured by an integrated steel shaft. Pedestals are constructed of a steel frame. Small radius casework construction and finishes applied such that no exposed seams appear at leading edges. Integrated panels easily removed for Preventative Maintenance. Tempered glass barriers are electronically controlled in both directions, via direct drive intelligent positioning (DDIP) induction sensor control motor. Sensor Detection: Provided through industrial duty infrared photoelectric beams. Operation: Fire Alarm Power Supply: A card is presented to the customer supplied access control reader mounted inside the casework. If authorized, the top green arrow light graphic will point in the direction authorized and a chime will sound to tell the user they may pass. The following modes can be set when the units are installed, and/or can be changed later through use of a push button on the desktop controller: Purely Optical (Always Open) Mode - The barrier arms are not used, and only audible alarms will signal unauthorized access attempts or tailgating activity. Full Time Barrier (Normally Closed) Mode The barriers remain closed until a valid Access control card is presented. Tailgaters and unauthorized entries are signaled by an alarm type tone. If an unauthorized card is presented, the lane will sound an alarm and the barrier arms will remain closed to prevent the user from proceeding further without intervention. Pop-Out (Normally Open) Mode The barrier arms remain retracted unless there is an invalid transaction attempted. The arms never pop out for free exit transactions. Tailgaters are still singled out with an alarm condition, but will not cause the arms to close. Input facility is available for voltage free contact supplied by others to effect fail state 120V AC 60Hz (50Hz available) The circuit is fed via a remote mounted step down transformer supplied with the unit. Product Description The OptiStile 720, in addition to being a standard optical turnstile, incorporates fully functional bidirectional barrier arms to deter all unwanted users, thus giving increased security control. The product has a 48 long footprint, for ease of monitoring by lobby staff. Users include Corporate HQ Commercial Government Financial Telecommunication Information Technology Banking Publishing Recreation Petrochemical Education Power Rating: Stand by Less than 0.5 AMP In operation Upto 8.0 AMP Logic Voltage: 24V DC OptiStile 720 Product Data Sheet US /2009

2 Standard Operating Modes: Status Lights: Switchable via optional Desk Top Controller (DTC) or an optional digital touch screen (HMI) Enter / Card In Exit / Card Out Free Exit / Card Out Optical or Barrier function Pop out Mode Closed Reset Uniquely designed Card Reader Pictograms are fitted into the OptiStile top, one for each direction, to visually assist the user when passing through the unit. Audible Notification: Each lane of the OptiStile has four discrete sounds to indicate the following: One tone - Reminder to swipe card. Chime - Access authorization. Two tone - Lane alert. Pictograms: 1.97 Dia. LED display pictograms flush mounted within the OptiStile lid top face (included as standard). The Green badge symbol is continuously illuminated indicating passage is available. Upon authorisation a Green arrow will illuminate in the direction of passage authorisation whilst in the opposite direction a Red cross symbol will illuminate to indicate the unit is not available for use or is already in use. Status Light User Instructions Normal Use Green Card (Rest mode) Present personal security card to the reader mounted upon the unit for authorisation. Wait for the Green Arrow to illuminate and the barrier to open. Green Arrow (Authorized use or designated free passage) Proceed through the unit. Note - For FREE PASSAGE configuration, authorisation is not required and is normally used for EXIT only. Red Cross (Unit in use or no passage) Wait until the passageway has been vacated and either the Green Card or Green Arrow to illuminate. (See above) Alarm Conditions Flashing Red Cross and Audible Alarm (Fraudulent condition) This alarm mode will be activated via the following scenarios; Passageway is already in use and a second person has attempted to follow through without authorization. (Tailgating) OR Passageway is currently in use and you do not have right of passage. Vacate the passageway. Wait for the flashing Red Cross to stop flashing and the Audible Alarm to cease. Wait for the Green Arrow to illuminate to indicate who has the right of passage. Flashing Green Card (Incorrect use mode) Remain in the lane and present personal security card to the reader mounted upon the unit for authorisation. Authorization of passage will cancel the alarm condition. Flashing Green Arrow (Emergency / Fire Exit) There is FREE PASSAGE to evacuate through the gate OptiStile 720 Product Data Sheet US /2009

3 Accessories and Optional Extras Alternative Materials, Finishes and Custom Design Refer to Gunnebo Entrance Control Inc for specific material design requirements. Alternative top and casework materials. Cardreader Mounting Integration of customer supplied readers into the OptiStile lid. Desk Top Control (optional) Simple console to control the OptiStile. Remote console to specific requirements. Digital touch screen with advance controls Alternative Mounting Specialist mounting base platform giving concealed cableway and requiring no drilling to the floor Lane Lights Mounted upon the vertical front section of the OptiStile to act as traffic light flow control, i.e.; Green arrow - lane open, Red arrow - lane closed and Flashing Red arrow - lane alarm. Installation Examples & Typical Layout Configuration OptiStile 720 2L/3P OPTISTILE 720 CARD IN/CARD OUT LIDS TOP CLADDING BLANK ACRYLIC INLAY DETAIL CARD IN ACRYLIC INLAY DETAIL (ENTER SIDE) CARD OUT ACRYLIC INLAY DETAIL ( EXIT SIDE ) END PANEL: MATERIAL: STAINLESS STEEL FINISH #4 BRUSHED GLASS CABINET PANEL MATERIAL: 1/2" TOUGHENED GLASS. FINISH: CLEAR BARRIER: MATERIAL: 3/8" [10MM] TOUGHENED GLASS FINISH CLEAR BASE PLINTHS OptiStile 720 Product Data Sheet US /2009

4 83.49 [2121] ADA EXIT STD EXIT [610] 2L/3P OPTISTILE 720 CARD IN/CARD OUT PED 4 (NEXT) ADA ENTER PED 3 (FIRST) STD ENTER PED 2 PLAN VIEW 2 [48] 2 [48] 6.50 [165] [1219] [955] [873.31] 5.52 [140.33] [914] ELEVATION VIEW [711] SIDE VIEW MOUNTING TEMPLATE (46.18 [1173]) 2.82 [72] (44.18 [1122]) [940] MOUNTING LOCATIONS 1.25" X.59" SLOT (TYP 8 PLCS) [1147] CONDUIT THRU HOLE 4" X 2" (TYP 2 PLCS) (2.75 [70]) (4.50 [114]) 3.25 [83] (6.50 [165]) (1.82 [46]) (3.82 [97]) (6.35 [161]) (5.50 [140]) (17.00 [432]) (31.00 [787]) (42.50 [1080]) [1219] IMPORTANT Any horizontal pipe or conduit runs below the OptiStile must be at least 5.5 below FFL. OptiStile 720 Product Data Sheet US /2009

5 For further information please contact: Gunnebo Entrance Control Inc. 535 Getty Court, Suite F, Benicia, CA Phone Fax Web ISO 9001 FM A COMPANY WITHIN THE GUNNEBO GROUP HEAD OFFICE SWEDEN Gunnebo AB, Box 5181, SE Goteborg, SWEDEN. Tel , Fax Note: In pursuit of its policy of continuous refinement and improvement, Gunnebo Entrance Control Inc reserves the right to modify design and details. OptiStile 720 Product Data Sheet US /2009