2015 /9C EN-00 OSRAM GmbH Marcel-Breuer-Str München Germany. LED module PL-LIN-HV-DC-G1. M see attached list

Transcription

1 Manufacturer's Declaration of Conformity with International Standards OSRAM fi Document number: Manufacturer or representative: Address: Brand name or trade mark: Product type: Product designation: OSRAM 2015 /9C EN-00 OSRAM GmbH Marcel-Breuer-Str München Germany LED module PL-LIN-HV-DC-G1 M see attached list Compliance with the International Standards marked in the Annex is confirmed. NOTE: If no International Standard applies, regional or national Standards may be referred to. Place and date of signature c. t /)/%LS QM QMIP S,g n atures: Names: Quality Management Mr. Alwin Veser Quality Assurance Mr. Bernhard Schemmel This declaration of conformity is issued under the sole responsibility of the manufacturer or representative. It confirms compliance with the indicated Standards, but implies no warranty of properties. This declaration is in conformity with the International Standard ISO/IEC "Conformity assessment Supplier's declaration of conformity Part 1: General ". This declaration is valid until further notice. NOTE: The "Manufacturer's Declaration of Conformity with International Standards" is independent of other declarations of conformity. 1/6

2 Manufacturer s Declaration of Conformity with International Standards Annex Document number: 2015 / 9C EN / 9C EN-00 The designated product(s) comply with the following International Standard(s) CISPR 15: IEC 60064: A1: A2: A3: A4: A5: IEC 60081: A1: A2: A3: A4: A5: IEC 60155: A1: A2:2006 IEC 60188: 2001 IEC 60192: 2001 IEC 60357: A1: A2: A3: IEC : A1: A2: IEC : A1: A2: IEC : IEC : Corrigendum 1: + Corrigendum 2: IEC : A1:1987 IEC : IEC : A1: IEC : 1997 IEC : 1998 IEC : A1:1996 IEC : A1: A2:1994 IEC : Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment Tungsten filament lamps for domestic and similar general lighting purposes Performance specifications Double-capped fluorescent lamps Performance specifications Glow-starters for fluorescent lamps High-pressure mercury vapour lamps Low pressure sodium vapour lamps Performance specifications Tungsten halogen lamps (non-vehicle) Performance specifications Incandescent lamps Safety specifications Part 1: Tungsten filament lamps for domestic and similar general lighting purposes Incandescent lamps Safety specifications Part 2: Tungsten halogen lamps for domestic and similar general lighting purposes Incandescent lamps Safety specifications Part 3: Tungsten halogen lamps (non-vehicle) Luminaires Part 1: General and tests Luminaires Part 2-1: Particular Fixed general purpose Luminaires Part 2-2: Particular Recessed Luminaires Part 2-3: Particular Luminaires for road and street lighting Luminaires Part 2-4: Particular Portable general purpose Luminaires Part 2-5: Particular Floodlights Luminaires Part 2-6: Particular Luminaires with built-in transformers for filament lamps Luminaires Part 2-7: Particular Portable for garden use Luminaires Part 2-8: Particular Handlamps 2/6

3 IEC : 2003 IEC : IEC : A1: IEC : 2010 IEC : A1: A2:2008 IEC 60662: IEC 60809: A1: A2: A3: A4: + A5: IEC 60810: A1: A2: IEC 60901: A1: A2: A3: A4: A5: IEC 60921: A1:2006 IEC 60923: A1:2006 IEC 60925: A1: A2:2001 IEC 60927: A1: IEC 60929: IEC 60968: IEC 60969: A1: A2:2000 IEC 60983: A1:2005 IEC : A1: A2: IEC : IEC 61047: 2004 IEC 61049: 1991 IEC 61167: IEC 61195: A1: Luminaires Part 2-10: Particular Portable for children Luminaires Part 2-12: Particular Mains socket-outlet mounted nightlight Luminaires Part 2-13: Particular Ground recessed Luminaires Part 2-20: Particular Lighting chains Luminaires Part 2-22: Particular Luminaires for emergency lighting High-pressure sodium vapour lamps Lamps for road vehicles Dimensional, electrical and luminous Lamps for road vehicles Peformance Single-capped fluorescent lamps Performance specifications Ballasts for tubular fluorescent lamps Performance Auxiliaries for lamps Balasts for discharge lamps (excluding tubular fluorescent lamps) Performance D. C. supplied electronic ballasts for tubular fluorescent lamps Performance Auxiliaries for lamps Starting devices (other than glow starters) Performance AC-supplied electronic ballasts for tubular fluorescent lamps Performance Self-ballasted lamps for general lighting services Safety Self-ballasted lamps for general lighting services Performance Miniature lamps Electromagnetic compatibility (EMC) Part 3-2: Limits Limits for harmonic current emissions (equipment input current 16 A per phase) Electromagnetic compatibility (EMC) Part 3-3: Limits Limitation of voltage changes, voltage fluctuations and flicker in public low voltage supply systems, for equipment with rated current 16 A per phase and not subjected to conditional connection DC or AC supplied electronic step-down convertors for filament lamps Performance Capacitors for use in tubular fluorescent and other discharge lamp circuits; Performance Metal halide lamps Performance specifications Double-capped fluorescent lamps Safety specifications 3/6

4 IEC 61199: + A1: IEC 61228: 2008 IEC : A1: A2: IEC : IEC : + Corrigendum 1: IEC : IEC : A1: Corr. 1: IEC : A1: A2:2006 IEC : A1:2008 IEC : Corrigendum:2001 IEC : A1:2010 IEC : 2006 IEC 61547: + Corr. 1:2010 IEC 61549: A1: A2: A3: IEC 62031: A1: IEC 62034: IEC 62035: A1: A2: IEC 62384: A1: IEC : IEC : IEC : XXXX IEC : IEC : Single-capped fluorescent lamps Safety specifications Method of measuring and specifying the UV-radiation of ultraviolet lamps used for sun-tanning Lamp controlgear Part 1: General and safety Lamp controlgear Part 2-2: Particular for d. c. or a. c. supplied electronic step-down convertors for filament lamps Lamp controlgear Part 2-3: Particular for a. c. supplied electronic ballasts for fluorescent lamps Lamp controlgear Part 2-7: Particular for battery supplied electronic controlgear for emergency lighting (self-contained) Lamp controlgear Part 2-8: Particular for ballasts for fluorescent lamps Lamp controlgear Part 2-9: Particular for ballasts for discharge lamps (excluding fluorescent lamps) Lamp controlgear Part 2-10: Particular for electronic invertors and convertors for high-frequency operation of cold start tubular discharge lamps (neon tubes) Lamp controlgear Part 2-11: Particular for miscellaneous electronic circuits used with Lamp controlgear Part 2-12: Particular for d. c. or a. c. supplied electronic ballasts for discharge lamps (excluding fluorescent lamps) Lamp controlgear Part 2-13: Particular for d. c. or a. c. supplied electronic controlgear for LED modules Equipment for general lighting purposes EMC immunity Miscellaneous lamps LED modules for general lighting Safety specifications Automatic test systems for battery powered emergency escape lighting Discharge lamps (excluding fluorescent lamps) Safety specifications DC or AC supplied electronic control gear for LED modules Performance Digital addressable lighting interface Part 101: General System Digital addressable lighting interface Part 102: General Control gear Digital addressable lighting interface Part 103: General Control devices Digital addressable lighting interface Part 201: Particular for control gear Fluorescent lamps (decive type 0) Digital addressable lighting interface Part 202: Particular for control gear Self-contained emergency lighting (decive type 1) 4/6

5 IEC : IEC : IEC : IEC : IEC : IEC : IEC : IEC : IEC : XXXX IEC 62493: IEC 62532: IEC 62560: + Corrigendum: IEC 62612: IEC 62639: IEC : IEC/PAS 62717: IEC/PAS : IEC/PAS : IEC/PAS : IEC/PAS : IEC/PAS : IEC/PAS : IEC 62471: 2006 Digital addressable lighting interface Part 203: Particular for control gear Discharge lamps (excluding fluorescent lamps) (decive type 2) Digital addressable lighting interface Part 204: Particular for control gear Low voltage halogen lamps (decive type 3) Digital addressable lighting interface Part 205: Particular for control gear Supply voltage controller for incandescent lmaps (decive type 4) Digital addressable lighting interface Part 206: Particular for control gear Conversion from digital signal into d.c. voltage (decive type 5) Digital addressable lighting interface Part 207: Particular for control gear LED modules (decive type 6) Digital addressable lighting interface Part 208: Particular for control gear Switching function (decive type 7) Digital addressable lighting interface Part 209: Particular for control gear Colour control (decive type 8) Digital addressable lighting interface Part 210: Particular for control gear Sequencer (decive type 9) Digital addressable lighting interface Part 211: Particular for control gear Optical control (decive type 10) Assessment of lighting equipment related to human exposure to electromagnetic fields Fluorescent induction lamps Safety specifications Self-ballasted LED-lamps for general lighting services by voltage > 50 V Safety specifications Self-ballasted LED-lamps for general lighting services by voltage > 50 V Performance specifications Fluorescent induction lamps Performance specification LED Binning Part 1: General and white grid LED modules for general lighting Performance Luminaire performance Part 1: General Luminaire performance Part 2-1: Particular for LED Cold cathode fluorescent lamps Part 1: Safety specifications Cold cathode fluorescent lamps Part 2: Performance specifications External electrode fluorescent lamps Part 1: Safety specifications External electrode fluorescent lamps Part 2: Performance specifications Photobiological safety of lamps and lamp systems 5/6

6 Manufacturer s Declaration of Conformity with International Standards Attached list Document number: 2015 / 9C EN / 9C EN-00 PL-LIN-HV-0650-XYY-280-DC-G1 PL-LIN-HV-1100-XYY-280-DC-G1 PL-LIN-HV-1300-XYY-560-DC-G1 PL-LIN-HV-2200-XYY-560-DC-G1 Name coding : PL-LIN-HV-1100-XYY-280-DC-G1 X : Ra index e.g. 8 = 80 YY : color temperature e.g. 30 = 3000K 6/6