Pack TYBOX Installation instructions

Transcription

1 Pack TYBOX 5000 EN Installation instructions

2 mesurée 18.4 C CHAUFFAGE SALON 19.0 C COMPOSITION Your PACK comprises: - 1 TYBOX 5000 connected room unit - 1 TYDOM 1.0 home automation and its connector or 2

3 CONTENT EN 1/ Location 4 2/ Connection Circulator control Control of the thermostat input of the boiler or heat pump (HP) no-reversible 5 3/ Mounting 7 4/ Installation 9 5/ Wireless association 10 6/ Configuration 13 7/ Troubleshooting Signals and possible faults on the wireless room thermostat TYBOX Signals and possible faults on the TYDOM / Technical characteristics 18 3

4 1/ LOCATION Since the temperature measurement sensor is inside the box, you must install the thermostat flush-mounting box: - on an accessible wall at a height of 1.50 m - away from heat sources (fireplaces, sunlight) and draughts (windows, doors) IMPORTANT: Do not install the thermostat on a wall in contact with the outdoors or with an unheated room (e.g. garage, etc.) The sleeve output in the flushmounting box must be blanked off (with mastic) in order to avoid unwanted air movements that could bias the sensor reading. 4

5 2/ CONNECTION EN The diagrams provided are simplified for greater clarity. Protections and other accessories required by standards are not illustrated. - Standard NF C and good practice must be complied with. Connected or nearby units must not generate excessive interference (directive 89/336/EEC). 2.1 Circulator control L N Circulator 2A max. / 230V~ TYBOX Control of the thermostat input of the boiler or heat pump (HP) no-reversible Thermostat input Boiler Thermostat input HP 2A max. / 230V~ 2A max. / 230V~ 5

6 2/ CONNECTION ❶ Remove the terminal, on the back of the device, using a screwdriver. ❷ Connect the terminal to the control wire (circulator, boiler or heat pump thermostat input). ❸ Fit the terminal back into its position

7 3/ MOUNTING ❶ Remove the thermostat cover by pushing the pin using a screwdriver. EN ❷ Attach the base by using suitable fixings for mounting. Fit the cover back onto the thermostat. ❸ Insert the batteries, with the right polarity Click 4 2 x 1,5V - AAA LR03 Click 7

8 4/ INSTALLATION A. Home automation gateway A for the smartphone and tablet TYDOM application B B. System status view LED C. Mains power supply D. Ethernet cable E. Ethernet port F. Not used G. Mains adaptor socket H. Configuration/Information button I. Connected TYBOX 5000 C D I E F G H Connect your TYDOM 1.0 depending on your installation. TYDOM 1.0 must be installed near your ADSL box line. ❶ Connect TYDOM 1.0 to the box with the Ethernet cable. ❷ Connect TYDOM 1.0 to the mains power supply. ❸ Download the TYDOM application - Depending on your unit: Login to Google play or App Store - Search for and download the free 'TYDOM' application ❹ Configure the TYDOM application - Note down the last 6 characters of the MAC address of your TYDOM Open the TYDOM application ensuring you are connected to the local network via WIFI, then follow the on-screen instructions. You are now connected. 8

9 EN ❸ ❹ Tydom MAC : 001A25 xxxxxx 9

10 5/ WIRELESS ASSOCIATION Associate the TYDOM application with the connected TYBOX 5000 M SHUTTERS VOLETS open 4 allumés 4 on66ouverts CHAUFFAGE HEATING RÉGLAGES SETTINGS INSTALLATION ÉCLAIRAGES LIGHTING ÉCLAIRAGES LIGHTING SHUTTERS VOLETS Mesdevices My équipements Meshomes My domiciles 4 allumés 4 on PERSONALISATION PERSONNALISATION PERSONNALISATION PERSONALISATION ON en surveillance activated active en surveillance Photos Photos Groupes Groups Groupes Groups Photos Photos Reception Accueil Prog. GÉNÉRAL GENERAL CAMERAS CAMÉRA Alerts Alerte Alerte Alerts À propos About À propos About SUPPORT activated active SUPPORT Help Aide Help Aide Photos Photos Scenario Scénario 19:41 SETTINGS MesMy équipements devices My homes PERSONALISATION Volet salon living room Scenarios Volet chambre bedroom DELTA 8000 Volet cuisine kitchen Photos Chauffage Heating bedroom Garage DELTA 8000 kitchen Lumière living salon room Alerts Lumière bedroom chambre About Lumière kitchen cuisine living room bedroom kitchen Lumière living salon ro Lumière bedroom chambre Lumière bedroom chambr Lumière kitchen cuisine Lumière kitchen cuisine Alarme Alarm Étape22 Step sur22 on Volets 9: AjA Étape22 Step sur22 on Éclairage Heating Chauffage Heating Electric Garage Électrique Electric Gate Hydraulique Hydraulic Alarm ON Hydraulic Garage Garage Appuyez Press 3 secondes the RH button sur la touche on the Appuyez receiver depress droite 3 secondes the de RH la button sur la touche on the Faites receiver depress droite 2 appuis the deleft bref la button sur la touche briefly Faites twice, depress gauche, 2 appuis the left brefb Gate Consommation Portail Gate Consommation passerelle for 3jusqu à seconds ce until que laled LED2passerelle 2flashes, clignote, for 3jusqu à puis seconds ce until que laled LED22flashes, clignote, LED la LED puis 2 should 2 doit faire flash33flashs. times. LED la LED 2 shou 2 do then relâcher. release. then relâcher. release. Maintenant Nowappuyez press "Associate". sur "ASSOCIER". Maintenant Nowappu pres Alarm Cameras ON Alarme Alarm Caméra Cameras ON Others Autres Others SUPPORT TOASSOCIER ASSOCIATE Help ÉCLAIRAGES LIGHTING Lumière living salon room Heating Portail Gate ON LIGHTING ÉCLAIRAGES LIGHTING GENERAL Volet cuisine kitchen living room Groups Volet chambre bedroo Volet cuisine kitchen SELECT A DEVICE SÉLECTIONNEZ SELECT A DEVICE UN ÉQUIPEMENT Étape11 Step sur22 on Éclairage SHUTTERS VOLETS SHUTTERS Volet chambre bedroom Étape11 Step sur22 on Volets a device a device un équipement Volet salon living ro Scenario Scénario SELECT A DEVICE SÉLECTIONNEZ SELECT A DEVICE UN ÉQUIPEMENT My devices VOLETS SHUTTERS ❷ Select 'My devices' My devices INSTALLATION a device un équip Website Site Internet Prog. ❶ Select the 'SETTINGS' icon on the home screen. 9: MesMy éqd Volet salon living room ÉCLAIRAGES LIGHTING GÉNÉRAL GENERAL Website Site Internet Reception Accueil a device un équipement Scénarios Scenarios ouvert open ON MesMy équipements devices VOLETS SHUTTERS Scénarios Scenarios PORTAIL GATE ALARME ALARM CAMERAS CAMÉRA INSTALLATION Meshomes My domiciles ouvert open 19.5 C ALARME ALARM 19:41 19:41 RÉGLAGES SETTINGS Mesdevices My équipements PORTAIL GATE CHAUFFAGE HEATING 19.5 C 19:41 19:41 TYDOM open 66ouverts NGS GES der TYDOM TOASSOCIER ASSOCIATE Expert mode Mode expert Expert mode Consommation Consommation Cameras Caméra Cameras TOASSOCIER ASSOCIATE TOASS AS Others Autres Others Website ❸ Select ' a device' 10 ❹ Select 'Heating' AM 9:41 MesMy équipements devices 9:41 AM My devices CHAUFFAGE HEATING 9:4 Ajo A H

11 Press the RH bu for 3 seconds then TO AS EN 9 SELECT A DEVICE Step 1 on 3 Heating Electric Hydraulic Garage TYBOX 5000 ON Gate Alarm Consommation Press 3 secon On the "mo Cameras Others TO AS ❺ Select 'Hydraulic' ❻ Swipe your finger over the screen to select 'TYBOX 5000' 9 HEATING PROGR GROUPE TOTAL BATHROOM LIVING ROOM LUN. 02:00 19,5 C 03:00 04:00 mode TO ASSOCIATE Terminé 1 équipement trouvé. OK mode 05:00 06:00 07:00 08:00 09:00 10:00 mode / + > 3s Reception Photos Prog. Scenario mode Room temperature 17,5 C mode / + 11:00 12:00 13:00 14:00 15:00 16:00 ❼ Next, follow the instructions displayed on the screen. Reception Photos Prog. Scenario Rooms Reception Photos 11 9 Annuler Nouve

12 6/ CONFIGURATION This menu is used to determine all the settings adapted to your installation. ❶To enter configuration mode, press the MODE button for 10 seconds until the screen displays CF01. ❷Press + or - to set. ❸Briefly press MODE to go to the next menu. Press MODE or wait 5 seconds to exit. CF01 - Correcting the temperature measured Setting from -5 C to +5 C Example: If the temperature displayed by the unit is 15 C and the actual temperature (thermometer) is 16 C, set +1 C. CF02 - Settings lock 0 No locking (default setting) 1 Total locking 2 Partial locking. Modification of the temperature setting at +/-2 C The screen will display if it is locked To unlock (selection 1 and 2), simultaneously press + or - the buttons for 10 seconds. CF04 - Frost protection mode temperature setting Setting of 5 C to 15 C. Default value: 10 C. 12

13 CF05 - Type of temperature displayed in AUTO mode EN 0 Temperature setting display (default selection) 1 Display of the measured room temperature. 1: Pressing the + or - button once displays and sets the temperature setting (in ON mode). CF06 - Regulation time base minutes (default settings) minutes minutes minutes On/Off On/Off CF07 - Modification of the on/off regulation hysteresis Only displayed if menu CF06 = on/off Setting of 0.2 C to 2 C. Default value: 0.4 C CF08 - Anti-seize function The Anti-seize function activates the circulator 1 minute per day to prevent any seizing up during a non-heating period. 0 Anti-seize disabled 1 Anti-seize enabled (default settings) 13

14 6/ CONFIGURATION CF09 - Reversal of relay direction The relay contact is normally open. It closes during a heating request. You can reverse the direction of operation. 0 Normally open (default selection) 1 Normally closed CF10 - Return to initial settings This menu resets all the CF01 to CF09 settings to their default value. By default CF10 = 0. To reset, press + to display 1 and confirm by pressing MODE. Association with a door/window magnetic contact (DO / MDO / DOI TYXAL+) If a door/window magnetic contact (e.g. window) is associated with the TYBOX 5000, the heating switches to Frost Protection mode when an open window is detected. ❶ Press the + and MODE buttons simultaneously until the screen shows for example rf00. ❷ On the door/window magnetic contact, press the button. ❸ Check that the screen evolved and shows rf01 on TYBOX mode mode 14 mode / + > 3s mode / +

15 7/ TROUBLESHOOTING 7.1 Signals and possible faults on the wireless room thermostat TYBOX 5000 EN When you press a button, the screen displays: Access to the settings is locked. To unlock, press and hold the + and - buttons for 10 seconds. IMPORTANT: if you want to lock the device again, refer to the configuration menu (CF02). >10s mode The screen displays the low battery symbol The batteries are spent.. Replace the batteries. 2 x 1,5V - AAA LR03 15

16 7/ TROUBLESHOOTING 7.2 Signals and possible faults on the TYDOM 1.0 LED Green and flashing Green on and steady Orange and flashing Orange and steady Red and steady System status System accessible locally and remotely, user logged in System accessible locally and remotely System accessible locally, user logged in System accessible locally No allocated IP address Diagnostic function Briefly press the button (viewing the LED for 10 seconds) Yellow and flashing Blue and flashing Blue and flashing (2x) Blue and flashing (3x) Flashing red Fixed IP OK DHCP OK / Upnp OK DHCP OK / Upnp Error Check that the Upnp is activated on the BOX DHCP in progress Check that the DHCP is activated on the BOX No network connection Check the Ethernet connection 16

17 EN Advanced functions LED Magenta and flashing (slowly) Fixed DHCP/IP Press the button for at least 3 seconds Action Release the button (within 15 seconds) It is advised to use the TYDOM application to access this function. LED Magenta and flashing (rapidly) Delete password Press the button for at least 15 seconds Action Release the button (within 30 seconds) LED System status RESET Press the button for at least 30 seconds Release the button Use of DHCP Delete password Clear associations Action 17

18 8/ TECHNICAL CHARACTERISTICS Wireless room thermostat TYBOX 5000 Contact output 2A (230V) Ball test: 125 C Rated surge voltage: 4000V Powered by 2 lithium batteries 1.5 V, LR03/AAA (supplied) Class III insulation Radio frequency MHz to MHz Maximum wireless power: <10 mw Wireless remote control device Wireless range: 100 to 300 metres outside, variable depending on the associated equipment (the range can vary depending on the installation conditions and the electromagnetic environment) Dimensions: 80 x 84 x 21 mm Degree of protection: IP 20 Wall mounting Installation in an environment with normal pollution levels Storage temperature: -10 to +70 C Operating temperature: 0 to +55 C 18

19 EN TYDOM 1.0 home automation box Main power supply 100 V~/240 V~, +/-10%, 50/60 Hz 0,3A, OUTPUT : 5V 1,0 A Radio frequency MHz to MHz Maximum wireless power: <10 mw Wireless range: 100 to 300 metres outside, variable depending on the associated equipment (the range can vary depending on the installation conditions and the electromagnetic environment) Class III insulation Dimensions: 100 x 100 x 30 mm Degree of protection: IP 30 Operating temperature: -10 to +40 C Storage temperature: -20 to +70 C Installation in an environment with normal pollution levels The connection quality of your product may be affected due to changes on the IP architecture on which it operates. These changes may involve (the list is not exhaustive) a change in hardware, software update or configuration operations, work on your operator's equipment or any other multimedia devices such as tablets, smartphones, etc.' Android and Google play are Google Inc trademarks. IOS is a Cisco Systems Inc trademark. WiFi is a Wireless Ethernet Compatibility Alliance trademark. Because of changes in standards and equipment, the characteristics given in the text and the illustrations in this document are not binding unless confirmed. 19

20